High Efficiency Vertical Geothermal Heat Pump:

These units are multi positional, any unit can be set up as L/H or R/H return. The control box sits on top of the unit so it is easy to wire. This is the most servicable unit we have ever sold!

Warranty: 10 year parts, 10 year labor allowance, Filter Racks Sold Separately

Epic Control option is not stocked at this time but we can order units that have it. Epic allows the owner to track the unit's operating cost over time and has enhanced diagnostic capabilities over the web.

The HVT is a compact 2-stage vertical heat pump. it is efficient and well built. to keep the costs down we buy these units with a 10 year parts warranty but only a 5-year labor allowance warranty. You must choose a L/H return or R/H Return and the duct heater fits on top of the unit.

Facing the unit, if the return is on YOUR left, it is a L/H return.

Filter Rack Sold Separately

Hydron Module's HBT indoor split system has water and refrigerant piping in the back left corner so your piping can stay at the wall.

Warranty: 10 year parts, 10 year labor allowance

These units use brazed-plate S.S. heat exchangers. We don't stock them at this time but we can order them from Enertech.

Warranty: 10 year parts, 10 year labor allowance

We stock these in smaller sizes such as 1.3 and 1.5-ton. Those sizes are not available in the 2-stage HVT line. To keep costs down we order these with 10 year parts warranty and 5-year labor allowance warranty

Facing the unit, if the return is on YOUR left, it is a L/H return.

Filter Rack Sold Separately

The HHP unit is a 2-ton water-to-water unit that has an option for a double-vented load side coax to make domestic hot water. You will need a storage tank (Usually a 50 gal electric water heater)

it can also be built with a standard coax for small radiant jobs such as a basement.

The HWT is a high efficiency 2-stage water to water unit. we stock 3-ton and 5-ton units.

Warranty: 10 year parts, 10 year labor allowance

These air handlers can be connected to a water-to-water unit to make forced air heat or A/C.

This is an air source heat pump that can heat or chill water to deliver heat to the home through forced air or in-floor radiant tubing. it also has a domestic hot water mode.

It has a vapor injection compressor which enables It to heat water to 135 degrees when the outdoor temperature is below zero degrees F. it is a packaged unit so there is no refrigeration work needed on site. The heating C.O.P. numbers are impressive. to read about this unit go to: https://enertechusa.com/products/air-source